Specifications
- sensor CCD 2,1 Megapixels
- resolution 1600x1200
- lens fixed focal length
- 8 MB internal memory
- SD memory card
- weight 210g with batteries
- 2 AA batteries, consumption 570mA
without screen, and 750mA with screen.
- numbering of pictures: Imag0001
which is reset at each all delete.
- price: 99 euros at Cora in 2003
|
|
The pictures got are beautiful, well exposed,
with a good saturation of colors and enough contrast.
For all the technical details,
or to read the instruction manual, let's go to Vivitar.com
This digital camera has a clone sold
in France under the trade mark I.T.works, and the model name
is Itshot 2070. The procedure is same as the vivicam..
At each power on, the auto shut-off function
of this camera can be programmed to 30mn. In this case, 3mn
after the power is on, the camera switch to idle mode. During
the remaining 27mn, it re-activates by pressing any button. |
The procedure to install a shutter release
plug is one of the most simple and not hazardous.
|
|
Dismounting
- remove the batteries and the memory card
- open the USB cover
- take off the 7 screws: one under (4mm) /2 under / 2
aside the strap ring (3mm) / 2 in the battery compartment,
(3mm) on the face cover.
- set off the top, by pressing on the back part: start
above the screen, and progress towards the battery compartment.
- set off the bottom, which must slide easily.
- When the two parts are enough disengaged, recover the
strap ring, and the USB cover.
- Open widely.
|
Install the plug:
- clear the wires under the flash window.
- prepare 3 female connectors of a bar 2,5mm step, which
will be placed under the flash tube.
- With the male plug draw the place for the holes, and
drill to 0.8/1mm
- prepare 2 thin wires 80mm long each, and solder on the
female plug.
- With some compound 2 components, set and fix the female
plug. use the male plug outside to center the female plug
inside and maintain it under complete setting.
|
|
|